Fixed an issue with certain turning rest area profile roughing operations where the final pass did not start at z clearance.Added the ability to specify 'wear' and 'inverse wear' compensation types in turning profile finishing operations.Fixed an issue with certain inside threading toolpaths with 'do multiple threads' turned on where threads were created that were crossing each other.

Fixed an issue in which full radius grooving tools with negative 'Stock to Leave' would result in an error.Fixed an issue in which the wrap radius was not updated when choosing a cylinder and the operation was not accepted.Improved linking in the pocket strategy with enabled rest machining to avoid air cutting ramps.Fixed a stock collision that could occur in 3D adaptive clearing when 'Order by Area' was selected.Fixed several cases where a ramp cutting into the part was generated.Fixed a toolpath calculation failure that could occur in a slot strategy which produced an 'Invalid Contours' error.

Fixed crashes that could occur in some cases when using the jet, spiral, or trace strategies.

Improved the 2D pocket and contour strategies to avoid having tiny arcs in cutting passes.

Fixed an issue in which the selected chain preview was not correct when changing the loops in 2D contour and 2D profile.Fixed a crash which could occur when clicking on a pattern in certain Inventor models.The following changes were made in an earlier update (2022.3): Fixed a crash that could occur when editing certain drill operations.Fixed an issue in which the tool could retract from an incorrect position at the end of a Profile Roughing toolpath.Installation WHAT’S NEW The following changes have been made in the current update (2022.3.1): This document covers these Inventor CAM products: Autodesk® Inventor CAM™ 2022.3.1 Release Notes

Inventor cam 2022